Filter
Top Products
8
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the bit
To remove the magnetic socket bit, first pull the locator out of
the locking sleeve. Then pull the magnetic socket bit.
To install the magnetic socket bit, insert it into the tool as far
as it will go. Then install the locator by pushing it firmly back
onto the locking sleeve.
OPERATION
Fit the screw on the point of the bit and place the point of the
screw on the surface of the workpiece to be fastened. Apply
pressure to the tool and start it. Withdraw the tool as soon as
the clutch cuts in. Then release the switch trigger.
CAUTION:
• When fitting the screw onto the point of the bit, be careful
not to push in on the screw. If the screw is pushed in, the
clutch will engage and the screw will rotate suddenly.
This could damage a workpiece or cause an injury.
• Make sure that the bit is inserted straight in the screw
head, or the screw and/or bit may be damaged.
1. Locator
2. Locking sleeve
1
2
002654
1. Locator
2. Magnetic socket bit
1
2
002662
002674