Filter
Top Products
6
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Depth adjustment
When you wish to drive self drilling screws, etc., adjust the
depth as follows. Turn the locator to adjust the depth.
Initially, adjust the locator to create a distance of approxi-
mately 1 mm (3/64”) from the tip of the front cap (which
works in conjunction with the locator) to the base of the
screw head. One full turn of the locator equals 1 mm (3/64”)
change in depth.
After adjusting the locator, turn the adjusting ring so that the
6” mark is aligned with the pointer on the gear housing. Drive
a trial screw into your material or a piece of duplicate mate-
rial. If the depth is not suitable for the screw, continue adjust-
ing until the proper depth setting is obtained.
1. Pointer
2. Locator
3. Front cap
4. Adjusting ring
1
2
3
4
002614
1mm (3/64")
002622
1mm (3/64")
002623