Filter
Top Products
5
1
3
2
4
005846
OPERATION
Bolt installation
Slip the tool onto the bolt so that the inner sleeve
completely covers the bolt tip.
1
2
004989
CAUTION:
• Be careful when fitting the sleeve onto the bolt tip.
Striking the tip can damage it so that it will no
longer fit inside the sleeve properly.
Keep forward pressure on the tool while sliding it further
forward until the outer sleeve fits completely over the nut.
If the tool fails to fit completely over the nut, twist the tool
slightly right and left while pushing forward.
1
2
004990
Pull the switch trigger. The outer sleeve turns to begin
tightening the nut.
When the specified torque is attained, the bolt tip will be
sheared at its notched portion. The bolt tip will remain
inside the inner sleeve.
1
2
004991
Release the switch trigger and withdraw the tool in a
straight line.
1
004992
Pull the tip ejector (tip lever) to eject the bolt tip from the
tool. Catch the sheared bolt tips to prevent them from
falling dangerously below. Keep the tips off of the ground,
floor, walkways, etc. to prevent injury from tripping or
falling.
1
004993
1
005847
CAUTION:
• Washer and nut have head and tail. Head has
identification mark for nut and chamfer for washer.
When placing them, be careful not to place in
reverse.
1. Tip ejector (Tip
lever)
1. Bolt tip
1. Outer sleeve
1. Notched portion
2. Bolt tip
1. Outer sleeve
2. Nut
1. Inner sleeve
2. Bolt tip
1. There should be
no gap between
the outer sleeve
and the tool.
2. Inner sleeve
3. Outer sleeve
4. Screw