Filter
Top Products
7
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing driver bit or socket bit
Use only the driver bit or socket bit shown in the figure. Do
not use any other driver bit or socket bit.
To install the bit, pull the sleeve in the direction of the arrow
and insert the bit into the sleeve as far as it will go. Then
release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the arrow
and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the sleeve, the
sleeve will not return to its original position and the bit
will not be secured. In this case, try re-inserting the bit
according to the instructions above.
Hook
The hook is convenient for temporarily hanging the tool. This
can be removed without using a tool.This can be installed on
either side of the tool.
Installing and removing hook
Expand the upper part of the hook in both directions and
remove it. To install the hook, follow the removal procedure
in reverse.
12 mm
(15/32”)
9 mm
(3/8”)
001266
1. Bit
2. Sleeve
1 2
001267
1. Hook
1
004355