Filter
Top Products
*Pressing down too hard on the tool will not speed up the drilling. In fact, this undue
pressure will only serve to damage the tip
of
your drill bit, decrease your drilling per-
formance and shorten the service
of
the tool.
*There
is
a
tremendous force exerted on the tool/bit
at
the time of hole break through.
Grip the drill firmly and exert care when the bit begins to break through the materials.
Item
Screw
Match your bit to your screw.
Nominal
Diameter
(mm)
Bit
No.
Wood
Screw
*I
2.1
-
2.7
13/32"
-
lis")
1.
Phillips bits
Phillips bit
No.
2
-
45
mm
is
standard
equipped. Select your screws and
right.
nominal diameter with the chart on the
No.
2
3.1
-
4.8
(118''
-
3/16")
2.
Slotted bits
Unless you use
a
bit that fits properly the slot on the head of the screw, the slot will
be damaged and the screw will not fasten. If the bit fails to match the slot, use
a
grinder or some such tool to trim the bit to fit the slot.
NOTE
:
Rest
the tool for
15
minutes when changing battery for continuous operation.
9