Filter
Top Products
Bit installation
&
removal
CAUTION
:
Always
set
the Forward-Reverse switch lever to NEUTRAL when installing, removing or
adjusting bits or accessories.
Chuck
When installing
a
drill bit, notice that
there are three holes in the chuck
at
which you must use the key for tighten-
ing. Insert the chuck key in any
of
the
3
holes and turn to the left (counterclock-
wise) to release jaws of chuck. Insert the
bit and tighten with chuck key to the
right. Tighten evenly
at
all
three holes in
sequence.
1
Clip-on
chuck
key
Overload protector
The overload protector automatically
cuts in to break the circuit and the
button pops out, whenever heavy work
is
prolonged.
Wait
20-30
seconds before
pressing the restart button (on housing
in back) to resume operation. Your finger
should
not be on the trigger when you
press the restart button, however.
/
Overload protector
I"