Filter
Top Products
HOW
TO
USE
Charging
Connect the charging plug to the charg-
ing connector, then plug
in
the charger to
the power receptacle. Charging takes
3
hours.
CAUTION:
The battery
in
your new tool
is
not fully
charged. You will need to charge it be-
fore
use.
Do
not operate the tool during charging.
Overcharging more than
2
days consid-
erably shortens the battery service life.
Always unplug the charger after completing the charge.
When you charge a new tool or a tool which has not been used for a long period, it
may not accept a
full
charge. This
is
a normal condition and does not indicate a
problem. You can recharge the tool fully after discharging it almost completely a
couple of times.
Installing and removing bit
To install the drill bit, place
it
in
the chuck
as
far
as
it
will go. Tighten the chuck collar
by hand. Place the cuck key
in
each
of
three holes, and tighten clockwise.
To
remove the drill bit, place the chuck
key into the chuck hole and
turn
counter-
clockwise.
CAUTION
:
Always set the Forward-Reverse switch lever to NEUTRAL when installing, removing or
adjusting bits
of
accessories.
6