Filter
Top Products
Switch action
Move the reversing switch lever to the
"FWD" position for clockwise rotation or
the
"REV"
position for counterclockwise.
To
start the tool, simply pull the trigger.
Release
the trigger to stop. When the re-
versing switch lever
is
in the neutral posi-
tion, the tool will not start even if you pull
the trigger.
*
CAUTION
:
0
Before inserting the battery cartridge into the tool, always check to
see
that the trigger
0
Always check the direction of rotation before drilling.
*Use the reversing switch lever only when the tool comes to
a
complete stop. Changing
When not operating the tool, keep the reversing switch lever in the neutral position.
Hammer drilling operation
Position the bit
at
the location for the
hole, then pull the trigger.
Do not force the tool. Light pressure
gives
best results. Keep the tool in position and
prevent
it
from slipping away from the
hole.
Do not apply more pressure when the hole
becomes clogged with chips or particles.
Instead, run the tool
at
an idle, then re-
move from the hole. By repeating this
several times, the hole will be cleaned out.
switch actuates properly and returns to the "OFF" position when released.
the direction of rotation before the tool stops may ruin the
tool.
.
Drilling operation
0
Drilling in wood
When drilling in wood, best results are obtained with wood drills equipped with
a
guide
screw. The guide screw makes drilling easier by pulling the bit into the workpiece.
To prevent the bit from slipping when starting
a
hole, make an indentation with
a
center-
punch and hammer
at
the point to be drilled. Place the point of the bit in the indenta-
tion and start drilling.
Use
a
cutting lubricant when drilling metals. The exceptions are iron and brass which
should be drilled dry.
0
Drilling in metal