Filter
Top Products
0
When
YOU
charge
a
new battery cartridge or
a
battery cartridge which has not been used
for
a
long period,
it
may not
accept
a
full charge. This
is
a
normal condition
and
does
not indicate
a
problem.
You
can recharge the battery cartridge fully after discharging
it
almost completely
a
couple of times.
If you wish to charge
two
battery cartridges, allow
15
minutes between chargings on the
fast charger.
Selecting action mode
Rotation with hammering:
For drilling in brick, concrete block,
etc.,
move the change lever to the
uou$>
posi-
tion. Be sure to use
a
concrete and masonry
drilling bit.
Rotation only
:
For drilling in
wood,
metal or
plastic
mate-
rials, move the change lever to the
GEE
position.
Use
a
conventional bit for drilling
in wood or metal.
Installing or removing drill bit or driver bit
CAUTION
:
Always be sure that the tool
is
switched off and the battery cartridge
is
removed before
installing or removing the bit.
Hold
the ring and turn the sleeve counter-
clockwise
to
open the chuck jaws. Place
the bit in the chuck as far as it will
go.
Hold
the ring firmly and turn the sleeve clock-
wise
to
tighten the chuck.
To
remove the bit, hold the ring and turn the
sleeve counter-clockwise.
When not using the driver bit, keep it in the
storage cavity on the tool.