Filter
Top Products
Installing or removing wheel point
CAUTION
:
Always be sure that
the
tool
is
switched
off
and
the
battery cartridge
is
removed before
installing or removing the wheel point.
Remove the guide from the tool when
it
is
installed on the tool. Loosen the wing bolt
and pull the guide off the front end of the
tool.
Press the shaft lock to lock the spindle in
place. Loosen the collet nut and insert the
wheel point into the collet nut.
Use the gauge (the gauge has
a
hex hole
which can be used
as
a
wrench) to tighten
the collet nut securely.
Shaft
lock
The wheel point should not be mounted
more than
10
mm
(3/8")
from the collet
nut. Exceeding this distance could cause
vibration or
a
broken shaft.
To
remove the wheel point, follow the installation procedures in
reverse.
7