Filter
Top Products
Specific Safety Rules
1.
Always use proper guard
with
grinding wheel.
A
guard protects operator from
broken wheel fragments.
2.
Accessories must be rated for at last the speed recommended on the tool
warning label. Wheels and other accessories running over rated speed can
fly apart and cause injury.
3.
Hold tool by insulated gripping surfaces when performing an operation where
the cutting tool may contact hidden wiring or its own cord. Contact with
a "live" wire will make exposed metal parts of the tool "live" and shock the
operator.
4.
Keep guards in place.
5.
Use only wheels having a maximum operating speed at least as high as
"No
Load RPM" marked on the tool's nameplate. When using depressed center
wheels, be sure to use only fiberglass-reinforced wheels.
6.
Check the wheel carefully for cracks or damage before operation. Replace
cracked
or
damaged wheel immediately.
7.
Use only flanges specified for this tool.
8.
Be careful not to damage the spindle, the flange (especially the installing
surface) or the lock nut. Damage to these parts could result
in
wheel
breakage.
9.
Hold the tool firmly.
IO.
Keep hands away from rotating parts.
11.
Make sure the wheel is not contacting the workpiece before the switch is
turned on.
12.
Before using the tool on an actual workpiece, let
it
run for a while. Watch
for
vibration or wobbling that could indicate poor installation or a poorly
balanced wheel.
13.
Use the specified surface of the wheel to perform the grinding.
14.
Watch out for flying sparks. Hold the tool
so
that sparks fly away from you
15.
Do not leave the tool running. Operate the tool
only
when hand-held.
16.
Do not touch the workpiece immediately after operation;
it
may be extremely
and other persons or flammable materials.
hot and could
burn
your skin.
SAVE THESE INSTRUCTIONS.
4