Filter
Top Products
8
OPERATION
Turn the tool on without the wheel point making any contact
with the workpiece and wait until the wheel point attains full
speed. Then apply the wheel point to the workpiece gently.
To obtain a good finish, move the tool in the leftward direction
slowly.
CAUTION:
• Apply light pressure on the tool. Excessive pressure on
the tool will only cause a poor finish and overloading of
the motor.
Dressing wheel point
When the wheel point becomes “loaded” with various bits
and particles, you should dress the wheel point with the
dressing stone.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
003496
1. Dressing stone
1
003498
1. Limit mark
1
001145