Filter
Top Products
8
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing abrasive belt
Pull the lever all the way out and install the belt over the roll-
ers, then return the lever to the original position.
CAUTION:
• When installing the belt, make sure that the direction of
the arrow on the back of the belt corresponds to the one
on the tool itself.
Adjusting belt tracking
Switch on the tool and make sure that the belt is aligned
properly. If the edge of the belt extends beyond the edge of
the base or the edge of the belt retracts more than 6 mm
(1/4”) away from the edge of the base, use the adjusting
knob to adjust the belt tracking.
Dust bag
Attach the dust bag onto the dust spout. The dust spout is
tapered. When attaching the dust bag, push it onto the dust
spout firmly as far as it will go to prevent it from coming off
during operation.
1. Lever
1
003501
003376
1. Steel plate
2. Adjusting knob
more than 6mm (1/4”)
1
2
003380
1. Dust bag
2. Dust spout
1
2
003385