Filter
Top Products
13
Operation
CAUTION:
• Make sure the safety system is in working order before
operation.
To start driving, place the tip of the nail against the driving
surface and pull the trigger. At the start of driving, apply gen-
tle downward pressure on the nailer in the arrow direction to
hold the nail firmly. When the impact of the contact arm
stops, the driving operation is over. If the nail is not driven
deep enough, place the ejection port of the nailer over the
nail head. Press the nailer against the driving surface firmly
and pull the trigger to do additional driving of the nail.
NOTE:
• The nailer will not operate unless you apply sufficient
pressure to the contact arm. If this occurs, apply forward
pressure to the nailer again while pulling the trigger to
start operation.
Nailing with one or two impacts
Whenyouneedtopositionanailordriveashallownail:
1. Set the tip of the nail firmly against the driving surface.
2. Pull the trigger.
3. Withdaw the nailer from the driving surface immediately
after one or two impacts.
NOTE:
• The impacts will continue as long as you keep the nailer
pressed up against the driving surface, even if you
release the trigger.
Nailing in metal plate holes
CAUTION:
• Always make sure that the tip of the nail is inserted in the
hole in the metal plate before you start nailing.
Driving surface
Trigger
Set the tip of the nail firmly
against driving surface.
1
Pull trigger.
2
Withdaw nailer from driving surface
immediately after one or two impacts.
3
Metal plate
Hole