Filter
Top Products
For No.
1
method, set the change lever to the “Intermittent
Nailing” position.
For No.
2
method, set the change lever to the “Continuous
Nailing” position. After using the change lever to change
the nailing method, always make sure that the change lever
is properly set to the position for the desired nailing method.
CAUTION:
Operating the tool without nails shortens the life of the tool and should be avoided.
Air exhaust
Air exhaust direction can be changed easily by rotating the
exhaust cover. Change it when necessary.
t
cover
I
Jammed nailer
CAUTION:
Always lock the trigger, disconnect the hose and remove the nails from the magazine before cleaning
a jam.
When the nailer becomes jammed, proceed as follows:
Open the door and magazine cap and remove the nail coil.
Insert a small rod or the like into the ejection port and tap
it with a hammer
to
drive out the nail jamming the ejection
port. Reset the nail coil and close the magazine cap and
door.
Hook
The hook is convenient for hanging the tool temporarily. This
hook can be installed on either side of the tool.
CAUTION:
*Always lock the trigger and disconnect the hose when hanging the
tool
using the hook.
*Always tighten the hook securing bolt firmly. Loose bolt may cause air leakage from the
tool.
14