Filter
Top Products
6
Connecting air hose
Lock the trigger. Slip the air socket of the air hose onto
the air fitting on the nailer. Be sure that the air socket
locks firmly into position when installed onto the air fit-
ting. A hose coupling must be installed on or near the tool
in such a way that the pressure reservoir will discharge at
the time the air supply coupling is disconnected.
OPERATION
CAUTION:
• Make sure all safety systems are in working order
before operation.
1. To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
2. Pull the trigger first and then place the contact ele-
ment against the workpiece.
• No. 1 method is for intermittent nailing, when you
wish to drive a nail carefully and very accurately.
No. 2 method is for continuous nailing.
CAUTION:
• However when the tool is set to the “Intermittent
Nailing” mode, WITH THE TRIGGER HELD IN A
HALF-PULLED POSITION, an unexpected nailing
could occur, if contact element is allowed to re-con-
tact against the workpiece or the other surface
under the influence of recoil.
In order to avoid this unexpected nailing, perform as
follows;
A. Do not place the contact element against the work-
piece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds after
nailing.
• For No. 1 method, set the change lever to the
position.
For No. 2 method, set the change lever to the
position.
After using the change lever to change the nailing
method, always make sure that the change lever is
properly set to the position for the desired nailing
method.
Anti dry fire mechanism
This tool is equipped with an anti dry fire mechanism.
When there are a few nails remaining in the magazine,
the contact arm will be locked in the undepressed posi-
tion to prevent the tool from being activated. Load more
nails to resume operation.
Jammed nailer
1. Nail stopper
1. Air socket
2. Air fitting
1
007010
1
2
007011
1
007012
2
007013
1. Continuous nail-
ing
2. Trigger lock
3. Lock lever
4. Intermittent nail-
ing
1. Hammer
2. Small rod
3. Ejection port
4. Driver
1
2
3
4
007014
1
2
3
4
004308