Filter
Top Products
9
Spade grip
The spade grip can be installed in any position as shown in
the figure. To change the position, loosen the hex bolts (both
sides) with a hex wrench and turn the spade grip to the
desired position. Then tighten the hex bolts securely. After
reposition the grip, return the hex wrench to the wrench
holder.
CAUTION:
• Do not fix the spade grip beyond the limits of the arrow.
Be cautious that your hand is not caught in the grip.
Keep the hand away from the drill chuck. They can lead
to serious accidents.
• Always be sure that the hex bolts (both sides) of the
spade grip are tightened securely.
Installing or removing drill bit
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each of
the three holes and tighten clockwise. Be sure to tighten all
three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just
one hole, then loosen the chuck by hand.
Afterusingthechuckkey,besuretoreturntotheoriginal
position.
1. Spade grip
2. Wrench holder
3. Hex wrench
1
2
3
003042
003043
1. Chuck key
1
003054