Filter
Top Products
Repair
oval hole of
F/R change
lever
protrusion of
Switch
P 12/ 14
[3] DISASSEMBLY/ASSEMBLY
[3]-9. F/R change lever, Wave washer, Cushion and Rubber pin 5 in Housing set
Fit the protrusion of Switch into Oval hole of F/R
change lever and assemble them to Housing L.
ASSEMBLING
Refer to Fig. 47.
Rubber pin 5
Pass Pin 1.5 through Rubber pin 5.
And then, assemble them to Battery
housing set (L) as illustrated right.
Assemble Cushion to Battery
housing set (L) at the rear side of
Terminal.as illustrated above.
Pin 1.5
Do not forget to put Wave
washer 15 in place for
holding Ball bearing
607DDW on the commutator
end of Armature.
Wave washer 15
Terminal
Battery housing set (L)
Housing set (L)
Fig. 47