Filter
Top Products
5
19.
Avoid cutting nails. Inspect for and
remove all nails from the workpiece before
operation.
20.
Make sure the shaft lock is released
before the switch is turned on.
21.
Be sure that the blade does not contact
the turn base in the lowest position.
22.
Hold the handle firmly. Be aware that the
saw moves up or down slightly during
start-up and stopping.
23.
Make sure the blade is not contacting the
workpiece before the switch is turned on.
24.
Before using the tool on an actual work-
piece, let it run for a while. Watch for
vibration or wobbling that could indicate
poor installation or a poorly balanced
blade.
25.
Wait until the blade attains full speed
before cutting.
26.
Stop operation immediately if you notice
anything abnormal.
27.
Do not attempt to lock the trigger in the on
position.
28.
Be alert at all times, especially during
repetitive, monotonous operations. Do
not be lulled into a false sense of security.
Blades are extremely unforgiving.
29.
Always use accessories recommended in
this manual. Use of improper accessories
such as abrasive wheels may cause an
injury.
30.
NEVER hold workpiece on right side of
blade with left hand or vice versa. This is
called cross-armed cutting and exposes
user to risk of SERIOUS PERSONAL
INJURY as shown in the figure. ALWAYS
use vise to secure workpiece.
31.
NEVER stack workpieces on the table top
to speed cutting operations. Cut only one
piece at a time.
32.
Some material contains chemicals which
may be toxic. Take caution to prevent dust
inhalation and skin contact. Follow mate-
rial supplier safety data.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.