Filter
Top Products
14.
REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to
see that keys and adjusting wrenches are removed from tool before turning
it
on.
15.
AVOID UNINTENTIONAL STARTING. Don't carry plugged-in tool with finger
on switch. Be sure switch is
OFF
when plugging in.
16.
OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only
extension cords intended for use outdoors and
so
marked.
17.
STAY ALERT.
Watch what you are doing, use common sense. Don't operate
tool
when you are tired.
18.
CHECK DAMAGED PARTS. Before further use of the tool, a guard or other
part that
is
damaged should be carefully checked to determine that
it
will
operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any
other conditions that may affect its operation.
A
guard or other part that
is damaged should be properly repaired or replaced by an authorized serv-
ice center unless otherwise indicated elsewhere in this instruction manual.
Have defective switches replaced by authorized service center. Don't use
tool
if
switch does not turn
it
on and off.
19.
GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded
surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.
20.
REPLACEMENT PARTS. When servicing, use only identical replacement parts.
21.
POLARIZED PLUGS: To reduce the risk of electric shock, this equipment has
a polarized plug (one blade
is
wider than the other). This plug will fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If
it
still
does not fit, contact a qualified electrician to install the
proper outlet. Do not change the plug in any way.
VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified for
the tool can result in
SERIOUS
INJURY to the user -as well as damage to the tool.
If
in doubt, DO NOT PLUG IN THE TOOL. Using a power source with voltage less
than the name plate rating is harmful to the motor.
ADDITIONAL SAFETY
RULES
1.
Hold the tool firmly.
2.
Do
not
leave
the tool running. Operate the tool only when hand-held.
3.
This tool has not been waterproofed,
so
do
not use water on the workpiece
SAVE THESE INSTRUCTIONS.
surface.
3