Filter
Top Products
7
Punch plate
When using the dust bag, make holes in the abrasive paper
using the punch plate as follows:
1. Set the tool upside down.
2. Place the punch plate over the abrasive paper so that
the bent sides of the punch plate are flush with the paper
edges.
3. Press the punch plate to make holes in the abrasive
paper.
CAUTION:
• Be sure to remove the punch plate before operating the
tool.
Dust bag
The use of the dust bag makes sanding operations clean and
dust collection easy. To attach the dust bag, fit the bag’s
entry port onto the dust spout on the tool. Make sure that the
hole in the bag’s entry port is just over the pimple-like protru-
sion on the dust spout.
For the best results, empty the dust bag when it becomes
approximately half full, tapping it lightly to remove as much
dust as possible.
OPERATION
Sanding operation
CAUTION:
• Never run the tool without the abrasive paper. You may
seriously damage the pad.
• Never force the tool. Excessive pressure may decrease
the sanding efficiency, damage the abrasive paper or
shorten tool life.
Hold the tool firmly. Turn the tool on and wait until it attains
full speed. Then gently place the tool on the workpiece sur-
face. Keep the pad flush with the workpiece and apply slight
pressure on the tool.
1. Punch plate
2. Sandpaper
3. Bent sides
1
2
3
003316
1. Dust bag
2. Hole
3. Protrusion
4. Dust spout
5. Entry port
1
2
3
4
5
003320
003335