Filter
Top Products
7
Installing or removing abrasive paper
For conventional type of abrasive paper with pre-
punched holes (standard equipment):
Turn the clamp lever counterclockwise. Insert the paper end
into the clamper, aligning the holes in the paper with those in
the pad. Then return the clamp lever to the original position
to secure the paper. Repeat the same process for the other
end of the tool, maintaining the proper paper tension.
For conventional type of abrasive paper without pre-
punched holes (optional accessory):
Turn the clamp lever counterclockwise. Insert the paper end
into the clamper, aligning the paper edges even and parallel
with the sides of the base. Then return the clamp lever to the
original position to secure the paper. Repeat the same pro-
cess for the other end of the tool, maintaining the proper
paper tension.
Place the punch plate (optional accessory) over the paper so
that the guide of the punch plate is flush with the sides of the
pad. Then press the punch plate to make holes in the paper.
For hook-and-loop type of abrasive paper with pre-
punched holes (optional accessory):
Remove all dirt or foreign matter from the pad. Attach the
paper to the pad, aligning the holes in the paper with those in
the pad.
CAUTION:
• Never use pressure-sensitive abrasive paper.
1. Clamp lever
2. Conventional type of abrasive
paper with pre-punched holes
3. Pad
1
2
3
001682
1. Punch plate
2. Conventional type of abrasive
paper without pre-punched holes
1
2
001683
1. Hook-and-loop type of abrasive
paper with pre-punched holes
2. Pad for hook-and-loop type of
abrasive paper
1
2
001684