Filter
Top Products
6
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing side grip (auxiliary handle)
1
003041
CAUTION:
• Always be sure that the side grip is installed
securely before operation.
Screw the side grip on the tool securely. The side grip
can be installed on either side of the tool, whichever is
convenient.
Spade grip
1
2
3
003042
003043
The spade grip can be installed in any position as shown
in the figure. To change the position, loosen the hex
bolts (both sides) with a hex wrench and turn the spade
grip to the desired position. Then tighten the hex bolts
securely. After reposition the grip, return the hex wrench
to the wrench holder.
CAUTION:
• Do not fix the spade grip beyond the limits of the
arrow. Be cautious that your hand is not caught in
the grip. Keep the hand away from the drill chuck.
They can lead to serious accidents.
• Always be sure that the hex bolts (both sides) of
the spade grip are tightened securely.
Installing or removing drill bit
1
003054
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise
in just one hole, then loosen the chuck by hand.
After using the chuck key, be sure to return to the
original position.
OPERATION
Holding tool
1
2
3
4
003078
1
2
003079
1. Reaction
2. Reverse
1. Reaction
2. Forward
3. Spade grip
4. Handle
1. Chuck key
1. Spade grip
2. Wrench holder
3. Hex wrench
1. Side grip