Filter
Top Products
8
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Spade grip
The spade grip can be installed in either of the positions as
shown in the figure. To change the location of the spade grip
from one position to the other, loosen the hex bolts with a
wrench and turn the spade grip to another position. Then
tighten the hex bolts securely.
Installing or removing drill bit
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each of
the three holes and tighten clockwise. Be sure to tighten all
three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just
one hole, then loosen the chuck by hand.
1. Spade grip
2. Hex. bolt
1
2
003038
003039
1. Chuck key
1
003051