Makita DC24SC Battery Charger User Manual


 
2
ENGLISH
Specifications
Model DC24SC
Input ........................................................................................................................................... A.C. 120 V 50 – 60 HZ
Output ...................................................................................................................................................D.C. 7.2 V – 24 V
Weight.......................................................................................................................................................1.3 kg (2.8 lbs)
Manufacturer reserves the right to change specifications without notice.
Note: Specifications may differ from country to country.
IMPORTANT SAFETY INSTRUCTIONS
CAUTION:
1. SAVE THESE INSTRUCTIONS — This manual contains
important safety and operating instructions for battery charger.
2. Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) bat-
tery, and (3) product using battery.
3. CAUTION — To reduce risk of injury, charge only MAKITA rechargeable batteries marked on the charger
label. Other types of batteries may burst causing personal injury and damage.
4. Non-rechargeable batteries cannot be charged with this battery charger.
5. Use a power source with the voltage specified on the nameplate of the charger.
6. Do not charge the battery cartridge in presence of flammable liquids or gases.
7. Do not expose charger to rain or snow.
8. Never carry charger by cord or yank it to disconnect from receptacle.
9. After charging or before attempting any maintenance or cleaning, unplug the charger from the power
source. Pull by plug rather than cord whenever disconnecting charger.
10. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage
or stress.
11. Do not operate charger with damaged cord or plug — replace them immediately.
12. Do not operate or disassemble charger if it has received a sharp blow, been dropped, or otherwise dam-
aged in any way; take it to a qualified serviceman. Incorrect use or reassembly may result in a risk of elec-
tric shock or fire.
13. The battery charger is not intended for use by young children or infirm persons without supervision.
14. Young children should be supervised to ensure that they do not play with the battery charger.
15. Do not charge battery cartridge when temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F).
16. Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.
17. Do not allow anything to cover or clog the charger vents.
Charging
1. Plug the battery charger into the proper AC voltage source. Charging light will flash in green color repeatedly.
2. Insert the battery cartridge into charger until it stops adjusting to the guide of charger. Terminal cover of charger
can be opened with inserting and closed with pulling out the battery cartridge.
3. When the battery cartridge is inserted, the charging light color will change from green to red and charging will
begin. The charging light will keep lighting up lit steadily during charging.
4. With finish of charge, the charging lights will change from two red ones to two green ones.
5. Charging time varies by temperature (10°C (50°F) – 40°C (104°F)) that battery cartridge is charged at and
conditions of the battery cartridge, such as a battery cartridge which is new or has not been used for a long period
of time.
6. After charging a Ni-MH battery, it is recommendable that the battery is left inserted in the charger for cool down
and trickle-charging. After 24 hours from completion of charging, remove the battery cartridge from charger and
unplug the charger.
7. After charging a Li-ion battery, leave it in the charger for about 30 – 60 minutes to cool down. And then remove it
from the charger and unplug the charger. Since Li-ion batteries have little self-discharge, trickle-charging is not
necessary.
NOTE:
The battery charger is for charging Makita-battery cartridge. Never use it for other purposes or for other
manufacturer’s batteries.
When you charge a battery cartridge which is new or has not been used for a long period of time, it may not accept a
full charge until after discharging it completely and recharging a couple of times. (Ni-MH battery only)