Filter
Top Products
28
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be per-
formed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the
prescribed maintenance work can lead to accidents!
Users of the Power Cut must not perform any maintenance work not described in this Instruction Manual. All such work must be
carried out by a MAKITA service centre.
Page
General Entire Power Cut Clean exterior, check for damage. In case of damage,
have repaired by a qualied service centre immediately
Cutting disc Inspect regularly for damage and wear. 7
Clutch Have inspected at a service center.
Protection hood Clean, Check position (impact plate) 16
Before each start Cutting disc Inspect for damage and make sure the cutting wheel is 7
right for the job
V-belt Check V-belt tension 19
Protective hood Adjust position
Combination switch, Functional check
Safety locking button, Functional check
Throttle lever Functional check 16
Tank cap Check for tightness and lekages
Every day Air lter Clean (if necessary more frequently); pre-lter (foam)
maintenance as described above under Cleaning /
changing the air lter 20-21
Idle speed Check (cutting disc must not turn on idle) 18
Extreme dust Clean lter insert (paper cartridge) 20-21
Every week Starter housing Clean to ensure proper air cooling 12
Starter cable Check for damage 23
V-belt Check V-belt tension, inspect for damage and wear 14, 19
Air lter insert Clean, replace after 100 operating hours 20-21
Spark plug Check and replace if necessary 22
Mufer Check tightness of mounting, clean or replace 12 / 26
spark arrester screen if necessary
Every 3 months Suction head Replace 22
Fuel tank Clean
Annually Entire Power Cut Check at an authorized service centre
Storage Entire Power Cut Clean exterior, check for damage. In case of damage,
have repaired by a qualied service centre immediately
Cutting disc Remove and clean 13
Fuel tank Empty and clean
Carburetor Run empty