Makita HM1202 Power Hammer User Manual


 
7
Center for this lubrication service.
Run the tool for several minutes to warm it up. Switch off
and unplug the tool.
Loosen the six screws and remove the handle.
1
002967
Remove the crank cap using a socket wrench. Rest the
tool on the table with the bit end pointing upwards. This
will allow the old grease to collect inside the crank
housing.
1
2
002968
Wipe out the old grease inside and replace with a fresh
grease (30 g; 1 oz). Use only Makita genuine hammer
grease (optional accessory). Filling with more than the
specified amount of grease (approx. 30 g; 1 oz) can
cause faulty hammering action or tool failure. Fill only
with the specified amount of grease.
1
002969
Reinstall the crank cap and tighten with the socket
wrench.
CAUTION:
Do not tighten the crank cap excessively. It is made
of resin and is subject to breakage.
Be careful not to damage the terminals or lead
wires especially when wiping out the old grease or
installing the handle.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point (SDS-max)
Cold chisel (SDS-max)
Scaling chisel (SDS-max)
Clay spade (SDS-max)
Bit grease
Hammer grease
Safety goggles
Plastic carrying case
1. Hammer grease
1. Socket wrench
2. Crank cap
1. Screws