Filter
Top Products
5
Number on adjusting dial Blows per minute
6 1,900
5 1,800
4 1,600
3 1,300
2 1,050
1 950
002898
CAUTION:
• The speed adjusting dial can be turned only as far
as 6 and back to 1. Do not force it past 6 or 1, or the
speed adjusting function may no longer work.
Indicator lamp
For HM1202C only
1
2
002899
The green power-ON indicator lamp lights up when the
tool is switched ON. If the indicator lamp is lit but the tool
does not start, the carbon brushes may be worn out, or
the electric circuit or the motor may be defective. If the
indicator lamp does not light up and the tool does not
start, the ON/OFF switch or the mains cord may be
defective.
The red service indicator lamp lights up when the carbon
brushes are nearly worn out to indicate that the tool
needs servicing. After approx. 8 hours of use, the motor
will automatically be shut off.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Side handle (auxiliary handle)
1
2
002903
The side handle can be swung 360° on the vertical and
secured at any desired position. It also secures at eight
different positions back and forth on the horizontal. Just
loosen the clamp nut to swing the side handle to a
desired position. Then tighten the clamp nut securely.
The side handle also can be mounted in the rear groove.
Loosen the clamp nut and widen the side handle base.
Slide the side handle back to the rear groove and secure
it with the clamp nut.
1
2
002904
Installing or removing the bit
Clean the bit shank and apply bit grease before installing
the bit.
1
2
002916
Insert the bit into the tool. Turn the bit and push it in until it
engages.
1
2
002922
If the bit cannot be pushed in, remove the bit. Pull the tool
holder cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the tool holder cover down all the
way and pull the bit out.
1. Bit
2. Tool holder
cover
1. Bit grease
2. Bit shank
1. Side handle
base
2. Clamp nut
1. Side handle
2. Clamp nut
1. Power-ON
indicator lamp
(green)
2. Service
indicator lamp
(red)