Filter
Top Products
14.
15.
16.
17.
18.
19.
20.
21.
REMOVE ADJUSTING
KEYS
AND WRENCHES. Form habit of checking to
see that keys and adjusting wrenches are removed from tool before turn-
ing
it
on,
AVOID UNINTENTIONAL STARTING. Don't carry plugged-in tool
with
finger
on switch. Be sure switch is OFF when plugging
in.
OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only
extension cords intended for use outdoors and
so
marked.
STAY ALERT. Watch what you are doing, use common sense. Don't oper-
ate tool when
you
are tired.
CHECK DAMAGED PARTS. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to determine that
it
will
operate properly and perform its intended function. Check for alignment
of moving parts, binding of moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation. A guard or other part
that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in this instruction manu-
al. Have defective switches replaced by authorized service center. Don't
use tool
if
switch does not
turn
it
on and off.
GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded
surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.
PROPER GROUNDING. This tool should be grounded while in use to pro-
tect the operator from electric shock.
EXTENSION
CORDS:
Use only three-wire extension cords which have three-
prong grounding-type plugs and three-pole receptacles which accept the
tool's plug. Replace or repair damaged or worn cord immediately.
VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY to the user
-
as well as damage to
the tool.
If
in doubt,
DO
NOT PLUG
IN
THE TOOL. Using a power source with
voltage less than the nameplate rating is harmful to the motor.
3