Filter
Top Products
7
1
010291
Then replenish with fresh grease (60g). Use only Makita
genuine hammer grease (optional accessory). Filling
with more than the specified amount of grease (approx.
60 g; 2 oz) can cause faulty hammering action or tool
failure. Fill only with the specified amount of grease.
To reassemble the tool, follow the disassembling
procedure in reverse.
For model HM1317CB only
1
2
010289
Remove the six screws using a hex wrench and remove
the rear cover.
1
010295
Pull out the crank cap cover in the direction of arrow and
remove it.
1
010296
Then replenish with fresh grease (60g). Use only Makita
genuine hammer grease (optional accessory). Filling
with more than the specified amount of grease (approx.
60 g; 2 oz) can cause faulty hammering action or tool
failure. Fill only with the specified amount of grease.
To reassemble the tool, follow the disassembling
procedure in reverse.
CAUTION:
• Be careful not to damage the brush holder unit and
carbon brushes especially when installing the rear
cover.
• Do not reuse the six bolts but use new ones in the
reassembling since these bolts are applied with
adhesive.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Bull point
• Cold chisel
• Scaling chisel
• Clay spade
• Rammer
• Hammer grease
• Safety goggles
• Plastic carrying case
1. Hammer grease
1. Crank cap cover
1. Rear cover
2. Hex wrench
1. Hammer grease