Filter
Top Products
8
Installing or removing the bit
Clean the bit shank and apply bit grease before installing the
bit.
Insert the bit into the tool. Turn the bit and push it in until it
engages.
If the bit cannot be pushed in, remove the bit. Pull the chuck
cover down a couple of times. Then insert the bit again. Turn
the bit and push it in until it engages.
After installing, always make sure that the bit is securely held
in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way and
pull the bit out.
Depth gauge
The depth gauge is convenient for drilling holes of uniform
depth. Insert the depth gauge into the hole in the grip base.
Adjust the depth gauge to the desired depth and then tighten
the clamp screw to secure the depth gauge.
NOTE:
• The depth gauge cannot be used at the position where
the depth gauge strikes against the tool body.
1. Bit shank
2. Bit grease
2
1
003150
1. Bit
2. Chuck cover
1
2
003158
1. Bit
2. Chuck cover
1
2
003163
1. Clamp screw
2. Depth gauge
1
2
003181