Filter
Top Products
8
Side grip (auxiliary handle)
The side grip swings around to either side, allowing easy
handling of the tool in any position. Loosen the clamp screw
on the side grip and swing the side grip to the desired posi-
tion. Then tighten the clamp screw to secure the side grip.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount of
bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck lubri-
cation assures smooth action and longer service life.
Installing or removing the bit
Clean the bit shank and apply bit grease before installing the
bit.
Insertthebitintothetool.Turnthebitandpushitinuntilit
engages.
If the bit cannot be pushed in, remove the bit. Pull the chuck
cover down a couple of times. Then insert the bit again. Turn
the bit and push it in until it engages.
After installing, always make sure that the bit is securely held
inplacebytryingtopullitout.
1. Side grip
2. Clamp screw
1
2
003143
1. Bit shank
2. Bit grease
2
1
003150
1. Bit
2. Chuck cover
1
2
003158