Filter
Top Products
2
ENGLISH (Original instructions)
SPECIFICATIONS
Model HR2470/HR2470F HR2470T/HR2470FT
Tungsten-carbide tipped bit 24 mm
Core bit 54 mm
Concrete
Diamond core bit (dry type) 65 mm
Steel 13 mm
Capacities
Wood 32 mm
No load speed (min
-1
) 0 - 1,100
Blows per minute 0 - 4,500
Overall length 370 mm 394 mm
Net weight 2.9 kg 3.0 kg
Safety class /II
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END201-5
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Read instruction manual.
･ DOUBLE INSULATION
･ Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible
recycling facility.
ENE043-1
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone as well as for chiselling work.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
ENF002-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
ENG102-3
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
pA
) : 90 dB(A)
Sound power level (L
WA
) : 101 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG215-2
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode : chiseling function
Vibration emission (a
h,CHeq
) : 12.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
ENG303-2
Work mode : hammer drilling into concrete
Vibration emission (a
h,HD
) : 15.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
ENG301-1
Work mode : drilling into metal
Vibration emission (a
h,D
) : 4.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.