Filter
Top Products
8
1
010718
Adjust the depth gauge to the desired depth by moving it
back and forth while pressing the lock button. After the
adjustment, release the lock button to lock the depth
gauge.
1
2
010719
NOTE:
• Inserting the depth gauge with its toothed side not
directed to the toothed side of hex hole marking on
the grip base as shown in the figure does not allow
the depth gauge to be locked.
Dust cup
1
010731
Use the dust cup to prevent dust from falling over the tool
and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in the
figure. The size of bits which the dust cup can be
attached to is as follows.
Bit diameter
Dust cup 5 6 mm - 14.5 mm
Dust cup 9
12 mm - 16 mm
006406
There is another type of dust cup (accessory) which
helps you prevent dust from falling over the tool and on
yourself when performing overhead drilling operations.
Installing or removing the dust cup
1
2
3
011506
Before installing the dust cup, remove the bit from the
tool if installed on the tool. Install the dust cup
(accessory) on the tool so that the
symbol on the
dust cup is aligned with the grooves in the tool.
1
2
010733
To remove the dust cup, pull the chuck cover in the
direction as shown in the figure and with the chuck cover
pulled take the bit out of the tool.
1
010734
And then grab the attachment at the foot of dust cup and
take it out.
1
2
011507
1. Bellows
2. Attachment
1. Attachment at
the foot of dust
cup
1. Bit
2. Chuck cover
1.
symbol
2. Grooves
3. Dust cup
1. Dust cup
1. Toothed side of
hex hole
marking on the
grip base
2. Toothed side of
the depth gauge
1. Lock button