Filter
Top Products
8
NOTE:
• Inserting the depth gauge with its toothed side not
directed to the toothed side of hex hole marking on
the grip base as shown in the figure does not allow
the depth gauge to be locked.
Dust cup (optional accessory)
1
010731
Use the dust cup to prevent dust from falling over the
tool and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in
the figure. The size of bits which the dust cup can be
attached to is as follows.
Bit diameter
Dust cup 5 6 mm (1/4") - 14.5 mm (9/16")
Dust cup 9 12 mm (15/32") - 16 mm (5/8")
006386
There is another type of dust cup which helps you
prevent dust from falling over the tool and on yourself
when performing overhead drilling operations.
Installing or removing the dust cup
(optional accessory)
1
2
3
014436
Before installing the dust cup, remove the bit from the
tool if installed on the tool. Install the dust cup on the
tool so that the
symbol on the dust cup is aligned
with the grooves in the tool.
1
2
014435
To remove the dust cup, pull the chuck cover in the
direction as shown in the figure and with the chuck
cover pulled take the bit out of the tool.
1
014441
And then grab the attachment at the foot of dust cup
and take it out.
1
2
011507
1
2
3
4
5
012895
1. Inside periphery
2. Carved side
3. Attachment
4. Cap
5. Groove
1. Bellows
2. Attachment
1. Attachment at the
foot of dust cup
1. Bit
2. Chuck cover
1.
symbol
2. Grooves
3. Dust cup
1. Dust cup