Filter
Top Products
6
For rotation with hammering, turn the knob so that the
arrow on the knob points toward the
symbol on the tool
body.
CAUTION:
• Always set the knob fully to your desired mode
symbol. If you operate the tool with the knob
positioned halfway between the mode symbols, the
tool may be damaged.
• Use the knob after the tool comes to a complete
stop.
For models HR2810, HR2810T, HR2811F, HR2811FT
Rotation with hammering
1
008206
For drilling in concrete, masonry, etc., rotate the action
mode changing knob to the
symbol. Use a
tungsten-carbide tipped bit.
Rotation only
1
008207
For drilling in wood, metal or plastic materials, lock
button and rotate the action mode changing knob to the
symbol. Use a twist drill bit or wood bit.
Hammering only
1
008208
For chipping, scaling or demolition operations, rotate the
action mode changing knob to the
symbol. Use a
bull point, cold chisel, scaling chisel, etc.
CAUTION:
• Do not rotate the action mode changing knob when
the tool is running under load. The tool will be
damaged.
• To avoid rapid wear on the mode change
mechanism, be sure that the action mode
changing knob is always positively located in one
of the three action mode positions.
Torque limiter
The torque limiter will actuate when a certain torque
level is reached. The motor will disengage from the
output shaft. When this happens, the bit will stop turning.
CAUTION:
• As soon as the torque limiter actuates, switch off
the tool immediately. This will help prevent
premature wear of the tool.
• Bits such as hole saw, which tend to pintch or
catch easily in the hole, are not appropriate for this
tool. This is because they will cause the torque
limiter to actuate too frequently.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Side grip (auxiliary handle)
1
2
3
4
008209
CAUTION:
•
Always use the side grip to ensure operating
safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Bit grease
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 - 1 g).
This chuck lubrication assures smooth action and longer
service life.
1. Grip base
2. Side grip
3. Teeth
4. Protrusion
1. Action mode
changing knob
1. Action mode
changing knob
1. Action mode
changing knob