Filter
Top Products
12
Use a screwdriver to remove the brush holder caps. Take out
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
Lubrication
CAUTION:
• This servicing should be performed by Makita
Authorized or Factory Service Centers only.
This tool requires no hourly or daily lubrication because it
has a grease-packed lubrication system. It should be relubri-
cated after every 6 months of operation. Send the complete
tool to Makita Authorized or Factory Service Center for this
lubrication service. However, if circumstances require that
you should lubricate it by yourself, proceed as follows.
Run the tool for several minutes to warm it up. Switch off and
unplug the tool.
Loosen the six screws and remove the handle. Note that the
top screws are different from other screws.
Disconnect the two terminals (white and black) by pulling
them.
1. Screwdriver
2. Brush holder cap
1
2
003232
1. Screws
1
003237
1. Black
2. Terminals
3. White
1
23
003240