Filter
Top Products
10
1
014036
Remove the connector by pulling it.
3
1
2
014038
Loosen the screws and remove the change lever.
Remove the crank cap cover.
1
014039
Remove the control plate.
1
1
1
2
014092
Loosen the six screws and remove the crank cap. Rest
the tool on the table with the bit end pointing upwards.
This will allow the old grease to collect inside the crank
housing.
1
014041
Wipe out the old grease inside and replace with fresh
grease:
For model HR4003C, HR4013C: 30g (1oz)
For model HR5202C, HR5212C: 60g (2oz)
Use only Makita genuine hammer grease (optional
accessory). Filling with more than the specified amount
of grease can cause faulty hammering action or tool
failure. Fill only with the specified amount of grease.
Reinstall all removed parts.
1
014042
Attach the connector and reinstall the handle.
NOTE:
Note that the different lengths of screws are used.
NOTICE
• Do not tighten the crank cap excessively. It is
made of resin and is subject to breakage.
• Be careful not to damage the connector or lead
wires especially when wiping out the old grease or
installing the handle.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
1. Connector
1. Hammer grease
1. Screws
2. Crank cap
1. Control plate
1. Change lever
2. Screw
3. Crank cap cover
1. Connector