Filter
Top Products
5
5.
Do not cut oversize workpiece.
6.
Check for the proper clearance beyond
the workpiece before cutting so that the
blade will not strike the floor, workbench,
etc.
7.
Hold the tool firmly.
8.
Make sure the blade is not contacting the
workpiece before the switch is turned on.
9.
Keep hands away from moving parts.
10.
Do not leave the tool running. Operate the
tool only when hand-held.
11.
Always switch off and wait for the blade to
come to a complete stop before removing
the blade from the workpiece.
12.
Do not touch the blade or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
13.
Some material contains chemicals which
may be toxic. Take caution to prevent
working dust inhalation and skin contact.
Follow material supplier safety data.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
SYMBOLS
USD201-2
The followings show the symbols used for tool.
V
.......................volts
A
.......................amperes
Hz
.....................hertz
................alternating current
....................no load speed
....................Class II Construction
.../min
................revolutions or reciprocation per
minute
n
˚