Filter
Top Products
Lubrication
Before operation, lubricate the contact
point of the center blade and the pin. To
keep good cutting performance, also use
a
cutting lubricant from time to time during
operation.
Switch
action
To
start the tool, move the slide switch
forward, and the slide switch will lock in
the
"ON"
position.
To
stop, lightly depress
the
rear
of
the slide switch, and
it
will
re-
turn to the
"OFF"
position.
CAUTION
:
Before plugging in the tool, always check
to
see
that the slide switch actuates pro-
perly and returns
to
the
"OFF"
position
when depressed.
Operation
Turn the tool on and
set
the front ends
of the side blades on the workpiece. Now
simply move the tool forward, keeping
the side blades flush with the workpiece
surface. When cutting curves, advance the
tool very slowly.
CAUTION
:
When cutting
a
small portion of the work-
piece,
you
may have difficulty complet-
ing the end of the cut. In that
case,
try to
cut
it
again, pulling the workpiece back
slightly.
1
Slide
switch
5