Filter
Top Products
26
Turn the 0° bevel angle adjusting bolt on the right
side of the arm two or three revolutions counter-
clockwise to tilt the blade to the right.
Carefully square the side of the blade with the top
surface of the turn base using the triangular rule,
try-square, etc. by turning the 0° bevel angle adjust-
ing bolt clockwise. Then tighten the lever securely.
Make sure that the pointer on the arm point to 0° on
the bevel scale on the arm holder. If it does not point
to 0°, loosen the screw which secures the pointer
and adjust the pointer so that it will point to 0°.
(2) 45° bevel angle
Adjust the 45° bevel angle only after performing 0°
bevel angle adjustment. To adjust left 45° bevel
angle, loosen the lever and tilt the blade to the left
fully. Make sure that the pointer on the arm points to
45° on the bevel scale on the arm holder. If the
pointer does not point to 45°, turn the 45° bevel
angle adjusting bolt on the left side of the arm until
the pointer points to 45°.
1. Lever
2. Arm
3. 0° bevel angle adjusting bolt
2
3
1
002188
1. Triangular rule
2. Saw blade
3. Top surface of turn base
1
2
3
001819
1. Pointer
2. Arm Holder
3. Bevel Scale
2
3
1
002189
1. Pointer
2. Lever
3. 45° bevel angle adjusting bolt
4. Arm holder
5. Arm
2
5
3
4
1
002190