Filter
Top Products
ADDITIONAL
SAFETY
RULES
1.
Wear eye protection.
2.
Do
not operate saw without guards
in
place.
3.
Don't use the tool in the presence of flammable liquids or gases.
4.
Check the blade carefully for cracks or damage before operation.
5.
Use only flanges specified for this tool.
6.
Be careful not to damage the arbor, flanges (especially the installing surface)
-
7.
Make sure that the turn base is properly secured
so
it
will not move during
8.
For your safety, remove the chips, small pieces, etc. from the table top before
9.
Avoid cutting nails. Inspect for and remove all nails from the workpiece before
Replace cracked or damaged blade immediately.
or bolt. Damage to these parts could result
in
blade breakage.
operation.
operation.
operation.
IO.
Make sure the shaft lock is released before the switch is turned on.
1
1.
Be sure that the blade does not contact the turn base
in
the lowest position.
12.
Hold the handle firmly. Be aware that the saw moves up or down slightly
during start-up and stopping.
13.
Do not perform any operation freehand. The workpiece must be secured
firmly against the turn base and guide fence with the vise during all
operations. Never use your hand to secure the workpiece.
14.
Keep hands out of path of saw blade. Avoid contact with any coasting blade.
It
can still cause severe injury.
15.
Never reach around saw blade.
16.
Make sure the blade is not contacting
the
workpiece before the switch is
turned on.
17.
Before using the tool on an actual workpiece, let
it
run for a while. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced blade.
18.
Wait
until
the blade attains full speed before cutting.
19.
Stop operation immediately if you notice anything abnormal.
20.
Do
not attempt to lock the trigger
in
the on position.
21.
Shut off power and wait for saw blade to stop before servicing or adjusting
tool.
22.
Be alert at all times, especially during repetitive, monotonous operations.
Don't be lulled into a false sense of security. Blades are extremely unforgiving.
23.
Always use accessories recommended in this manual. Use of improper
accessories such as abrasive wheels may cause an injury.
24.
Don't abuse cord. Never yank cord to disconnect
it
from the receptacle. Keep
cord away from heat, oil, water and sharp edges.
SAVE
THESE INSTRUCTIONS.
5