Filter
Top Products
6
Changing the hammering force
SH
SH
SH
SH
1
2
3
4
5
011217
Hammering force grade
displayed on panel
Maximum blows
Application Work
Hard
Medium
Soft
Tightening when force
and speed are desired.
Tightening when a good
finishing is needed.
Tightening when excessive
tightening need to be avoided
because of potentially clogged
female screw and broken or
damaged screw head.
Tightening in underwork
material/ Tightening long
screws/ Tightening bolts.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws
such as M6.
3,400 /min.
2,800 /min.
1,300 /min.
SH
SH
SH
011268
The hammering force can be changed in three steps:
hard, medium and soft.
This allows a tightening suitable to the work.
Every time the hammering force button
is pressed, the
number of blows changes in three steps.
For approximately one minute after releasing the switch
trigger, the hammering force can be changed.
NOTE:
• When all lamps on the switch panel go out, the tool
is turned off to save the battery power. The hammer
force grade can be checked by pulling the switch
trigger to the extent that the tool does not operate.
• During the operation of switch trigger, the hammer
force grade cannot be changed.
Empty signal for remaining
battery capacity
SH
1
011220
Pulling the trigger switch when the remaining battery
capacity become very low makes LED indicator flicker.
If the tool is used continuously with the LED indicator
1. LED indicator
1. Changed in
three steps
2. Hard
3. Medium
4. Soft
5. Hammering
force button