Filter
Top Products
10
Adjusting the fastening torque
The fastening torque can be adjusted in 6 steps by turning
the adjusting ring so that its graduations are aligned with the
pointer on the tool body. The fastening torque is minimum
when the number 1 is aligned with the pointer, and maximum
when the marking is aligned with the pointer.
The clutch will slip at various torque levels when set at the
number 1 to 5. The clutch is designed not to slip at the
marking.
Before actual operation, drive a trial screw into your material
or a piece of duplicate material to determine which torque
level is required for a particular application.
NOTE:
• The adjusting ring does not lock when the pointer is
positioned only halfway between the graduations.
• Do not operate the tool with the adjusting ring set
between the number 5 and the marking. The tool may
be damaged.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
Installing or removing driver bit or drill bit
Hold the ring and turn the sleeve counterclockwise to open
the chuck jaws. Place the bit in the chuck as far as it will go.
Hold the ring firmly and turn the sleeve clockwise to tighten
the chuck.
To remove the bit, hold the ring and turn the sleeve counter-
clockwise.
When not using the driver bit, keep it in the bit holders. Bits
45 mm (1-3/4”) long can be kept there.
OPERATION
Screwdriving operation
CAUTION:
• Adjust the adjusting ring to the proper torque level for
your work.
1. Pointer
2. Weak
3. Strong
4. Torque adjusting ring
1
2
3
4
002099
1. Tighten
2. Sleeve
3. Ring
1
2
3
002111