Filter
Top Products
7
Installing or removing socket
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing the socket.
Align the hole in the side of the socket with the detent pin on
the anvil and push it onto the anvil of the tool until it locks into
place. Tap it lightly if required.
To remove the socket, simply pull it off.
Hook
The hook is convenient for temporarily hanging the tool. This
can be removed without using a tool.This can be installed on
either side of the tool.
Installing and removing hook
Expand the upper part of the hook in both directions and
remove it. To install the hook, follow the removal procedure
in reverse.
1. Socket
2. Anvil
1
2
003998
1. Hook
1
004000