Filter
Top Products
7
Speed change
Two speed ranges can be preselected with the speed
change lever.
To change the speed, press the speed change lever and
slide it to the “LO” position for low speed or the “HI” position
for high speed. If the speed change lever does not slide eas-
ily, turn the chuck slightly in either direction while sliding the
lever.
Be sure that the speed change lever is set to the correct
position before operation. Use the right speed for your job.
CAUTION:
• Always set the speed change lever fully to the correct
position. If you operate the tool with the speed change
lever positioned halfway, the tool may be damaged.
• Do not use the speed change lever while the tool is
running. The tool may be damaged.
Selecting the action mode
This tool has an action mode changing knob.
For rotation with hammering, turn the knob so that the
mark is towards the small diamond marking on the tool body.
For rotation only, turn the knob so that the mark is towards
the small diamond marking.
CAUTION:
• Always turn the action mode changing knob all the way
to your desired mode position. If you operate the tool
with the knob positioned halfway between the mode
symbols, the tool may be damaged.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
1. Change lever
1
002417
1. Diamond marking
2. Action mode changing knob
1
2
002424