Filter
Top Products
Operation
CAUTION:
Make sure all safety systems are in working order before operation.
1)
To drive a nail, you may place the contact element against the workpiece and pull the trigger, or
2)
Pull the trigger first and then place the contact element against the workpiece.
No.
1
method is for intermittent nailing, when you wish to drive a nail carefully and very accurately.
No.
2
method is for continuous nailing.
1
//
//
/
For No.
1
method, set the change lever to the
“Intermittent Nailing” position.
For No.
2
method, set the change lever to the
“Continuous Nailing” position. After using the
change lever to change the nailing method,
always make sure that the change lever is properly
set
to
the position for the desired nailing method.
12
/
I-
Continuous
&.&
nailing
@!-
Change
lever
Trigger
lock
Anti dry fire mechanism
This tool is equipped with an anti dry fire mechanism. When there are a few nails remaining in the
magazine, the contact arm will be locked in the undepressed position to prevent the tool from being
activated. Load more nails to resume operation.
Jammed nailer
CAUTION:
Always lock the trigger, disconnect the hose and remove the nails from the magazine before cleaning
a jam.
When the nailer becomes jammed, do as follows:
Insert a small rod or the like into the ejection port and tap it with a hammer to retract the driver. Use
pliers to bend the jammed nail
so
that the nail head comes out of the slot in the driver guide. Then
remove the iammed nail.
Hammer
H
Small
rod
Ejection
port
Driver
14