Filter
Top Products
3
ENGLISH (Original instructions)
Explanation of general view
1-1. Shaft lock
2-1. Lock button
2-2. Switch trigger
3-1. Speed adjusting dial
6-1. Lock nut
6-2. Abrasive disc
6-3. Rubber pad
7-1. Lock nut wrench
7-2. Shaft lock
9-1. Exhaust vent
9-2. Inhalation vent
10-1. Commutator
10-2. Insulating tip
10-3. Carbon brush
11-1. Brush holder cap
11-2. Screwdriver
SPECIFICATIONS
Model SA7000C
Disc diameter 180 mm
Spindle thread M14
No load speed (n
0
) / Rated speed (n) 0 - 1,500 / 4,000 (min
-1
)
Overall length 453 mm
Net weight 3.4 kg
Safety class /II
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE052-1
Intended use
The tool is intended for the sanding of large surface of
wood, plastic and metal materials as well as painted
surfaces.
ENF002-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
ENG102-2
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
pA
) : 88 dB(A)
Sound power level (L
WA
) : 99 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG228-4
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745-2-3:
Work mode: disc sanding
Vibration emission (a
h,SG
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
If the tool is used for other applications, the vibration
emission value may be different.
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENH101-12
EC Declaration of Conformity
We Makita Corporation as the responsible
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
A
ngle Sande
r
Model No./ Type: SA7000C
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
EN60745