Filter
Top Products
To
secure the sub-magazine in place, push
the sub-magazine while pressing the plate
spring on the rear
of
the sub-magazine.
CAUTION
:
0
Always secure the sub-magazine in place, or the staples can drop out and cause problems.
With the magazine loaded,
if
the tool
is
held downward and the sub-magazine
is
opened,
the staples can fall out and present
a
danger to anyone or anything below. Keep this in
mind especially when working in high locations.
Depth
adjustment
If the staples are driven too deep or too
shallow, adjust the driving depth by turn-
ing the nut on the bottom
of
the tool. For
deeper driving of staples, turn the nut
clockwise. For shallower driving, turn the
nut counterclockwise. Please note the nut
must be turned in increments
of
180"
(1/2
turn)
so
that the groove on the nut runs
parallel to the magazine.
NOTE
:
If
the distance between the
tool
end
(A)
and the material to be fastened
is
more
than
2
mm
(5/64"),
the tool will not
operate because the safety lever
is
not
pressed enough to operate the tool.
I
hlllf
I
i
9