Filter
Top Products
6
Installing or removing driver bit or socket bit
12 mm
(15/32”)
9 mm
(3/8”)
001266
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure the
bit.
1
2
007509
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
OPERATION
The tool can be used in two ways; a straight type and a
pistol type which is selectable according to the
conditions of workplace and screwdriving.
007514
007515
CAUTION:
• When bending the tool to use in the pistol type or
straightening to use in the straight type, do not hold
the bendable part of the tool. Failure to do so may
cause your hand and fingers to be pinched and
injured by this part.
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
20
(15)
15
(11)
10
(7)
5
(4)
0 1.0 2.0 3.0
M8(5/16")
M6(1/4")
Standard bolt
N m
Fastening torque
Fastening time
S)
Proper fastening torque
(ft lbs)
(
(M8)
(M6)
(5/16")
(1/4")
007519
1. Bit
2. Sleeve